Wall drain · patented
Wall-In. The drain disappears into the wall.
The world's first wall drain that can be cut to size. The drain body sits inside the stud wall and the shower floor stays uninterrupted.
in the wallA shower floor with no channel and no interruption
80 · 100 · 120 cmcan be cut from 25 cm, wall-to-wall
60 mmBuild height from 60 mm, suitable for renovation too
Build-up
Finely adjusted, quickly installed.
The patented adjustable eccentric flange allows fine levelling, and the drain body adapts to the tile thickness. Installation stays simple and fast.
Channel body and cover can be cut to any size from 25 cm.
From shell to tile.
Keep scrolling: three steps, one picture.
Inside the stud wall.The drain body sits in the wall and the floor stays clear.
Remove the cover.Cleaning without tools, in seconds.
A floor in one piece.What remains is an edge of stainless steel on the wall.
Technical data.
| Material | Stainless steel 1.4301 / V2A (AISI 304) |
|---|---|
| Lengths | 80 · 100 · 120 cm, can be cut from 25 cm |
| Build height | from 60 mm |
| Installation steps | patented eccentric flange for fine levelling, drain body adapts to the tile thickness |
| Drain | DN 50 outlet, trap |
| Waterproofing | Waterproofing membrane fitted at the factory, abP |
| Testing | abP, EN 1253 |
Ordering information.
7 variants.
| Item number | Size | Surface |
|---|---|---|
| LW12-H24L100E1 | 100 cm | Brushed stainless steel |
| LW12-H24L120E9 | 120 cm | Brushed anthracite |
| LW9-H24L120E9 | 120 cm | Brushed anthracite |
| LW12-H24L120E1 | 120 cm | Brushed stainless steel |
| LW12-H24L80E1 | 80 cm | Brushed stainless steel |
| Project-specific versionsNot held in stock. Manufactured for your project; lead time on request. | ||
| LW12-H24L140E1 | 140 cm | Brushed stainless steel |
| LW12-H24L30E1 | 30 cm | Brushed stainless steel |
Identical for every variant: Material Stainless steel 1.4301 / V2A (AISI 304) · Outlet DN 50
Special lengths on request. Every channel can be cut to size on site.
Installation in five steps.
The order follows the site: shell first, tile last.
Stud wallPosition the drain body in the stud wall installation and connect it to the drainage.
ScreedLay the screed with a fall towards the wall.
WaterproofingBond the factory-fitted waterproofing membrane into the adjoining bonded waterproofing system, then seal wall and floor.
Tiling workTile the floor up to the underside of the trim, then the wall above it.
TrimAdjust the eccentric flange, fit the trim and peel off the protective film.